Blogs i write are mostly related to OSRC in one way or another, may it be a user manual, tutorial or something interesting for the reader. Since i developed the OSRC system, naturally writing information about it is my main priority. However now and then i do tend to write my own thoughts about other topics, related to technology.
Trim Settings
- Font size: Larger Smaller
- Hits: 9458
- 0 Comments
- Subscribe to this entry
- Bookmark
Besides the already available, dedicated Trim knobs on the Main Unit, the operator can also define the values as well as their incremental rate through these settings.
Trims can be thought of like the center offset values for each channel. If a motor or another output device on a model needs its center to be offset then these are the values that must be altered. Values altered in this section, are also controlled by the Trim Levers located near each Main Stick axis. The only difference of this section is that the operator can define the exact value, necessary for each of the 4 main channels.
Channel 1 - 4
By selecting the value associated with the corresponding channel, the operator may define a negative or positive offset value. The channel association to each Main Stick axis is relevant to the corresponding Mode selected within the Root Stick Settings
Mult/ier - Multiplier
The Multiplier value is what defines in how many increments shall the trim value be altered. For example if the Multiplier is set to 1 then every time the value is altered through the Trim Levers on the Main Unit or through this menu, the offset value shall be incremented by 1 unit. If the value is 10 or 20 then the increments shall be made with the same count.
"
